Digi-Sense Type K Manuál s instrukcemi stáhnout pdf (Strana 6)

Instruction Manual Type K Thermocouple Thermometer

2.3 Inserting & Removing the Rubber Boot / Stand (Optional

Purchase)

1. To remove meter from rubber boot, push out from the bottom edges of meter

until it is completely out of boot. Ensure that the connector of temperature

sensor is not connected.

2. To insert meter into rubber boot, slide in from the top of meter before pushing

the bottom edges of meter down to set it into position. Lift up the stand at the

back of meter for bench top applications if necessary.

Figure 3: Inserting meter into the rubber boot

2.4 Inserting New Batteries

The battery compartment is found at the back of instrument. To open the battery

compartment, push in the direction of arrow and lift up the cover. Note the polarity

of battery before inserting into position. After replacement, place cover back and

press down until it locks tight.

Figure 4: Battery compartment at the back of the meter

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Žádné komentáře

Digi-Sense Type K Manuál s instrukcemi Strana 6